Every layer of an automation panel

Sedona-based application controller. Control logic, field I/O and service interfaces in one device.

Highlights

• 16 DI · 8 DO · 8 UI · 8 FIO
• Sedona application model, point-based engineering
• Modbus, BACnet, MQTT and serial integration kits
• Web + BLE service, OTA updates, backup/restore

A field interface with a fixed Modbus and BACnet surface. Integrates without programming.

Highlights

• 16 DI · 8 DO · 8 UI · 8 FIO, counter/pulse on DI1–DI4
• UI: 0-10V, 2-10V, 0/4-20mA, NTC, PT1000, NI1000, resistance
• Fixed register map and BACnet object surface
• Fail-safe defaults and defined comms-loss behaviour

Protocol conversion and diagnostics for up to 64 slave devices over two independent RS-485 ports.

Highlights

• 32 slaves per port, separate baud rate and timeout
• Slave health monitoring and timestamped error log
• Browser-based configuration, live diagnostics panel
• Hardware/software watchdog, automatic UART recovery

Remote monitoring and control over SMS at sites without a fixed internet connection.

Highlights

• Modbus TCP/RTU conversion, 32 slaves on RS-485
• Status queries and control commands over SMS
• Automatic SMS notification on alarm conditions
• ESP32-C3 with multitasking FreeRTOS-based firmware

Dual-Ethernet BACnet IP router connecting network segments to each other.

Highlights

• Dual Ethernet ports
• Routing on BACnet/IP networks
• Device identity registered under ASHRAE Vendor ID 1600

Four fan-coil units from a single thermostat — a direct cut in thermostat and cabling cost.

Highlights

• Control of 4 separate fan-coils from one thermostat
• Panel type (FCU4) and DIN rail type (FCU4R) options
• 220 VAC supply, -40 °C … +70 °C operating range

Two-point water leak monitoring, straight into automation via a dry-contact relay output.

Highlights

• Two point-type sensors on a single unit
• NO-COM dry contact relay output
• 0–30 s adjustable alarm delay, snooze
• IP-54, DIN rail mounting, 24 VDC

One-piece weldless wells: sensor service without downtime, no leak path and no corrosion start point.

Highlights

• One-piece, non-welded manufacturing
• Stainless steel (EPL-SS) and brass (EPL-BW)
• 50 / 100 / 150 mm lengths, hex head (AF22)

Three-channel buffer board: amplifies the control signal in current without altering its voltage.

Highlights

• 3 independent isolated channels, no signal crosstalk
• Common collector (emitter follower) architecture
• Safe driving of motors, relays and solenoid valves

Our own Sedona programming and commissioning tool.

Highlights

• Application editing on a wiresheet
• Kit management, manifest browsing, get/put application
• Backup/restore, point discovery, device simulator